Found in almost all engines, the oil filter housing secures the oil filter into place. It is important in helping keep clean oil circulating around your engine. The oil filter housing on most cars is located in a spot that’s easily accessible for oil and filter changes, typically either on the top of the engine near the front or on the side of the engine with the filter accessible from the bottom;
If you are experiencing the following 5 Symptoms of a Bad Oil Filter: 1) Engine Overheating; 2) Weak Performance; 3) Dirty Exhaust Fumes; 4) Low Oil Pressure; 5) Metallic Noises on your Dodge and Jeep, You Need Oil Filter Housing Replacement;
Our Engine Oil Filter Adapter Housing with Sensors is manufactured from quality materials; With stable characteristics, high reliability, designed to meet or exceed the standards of original factory oil filter; Direct Replacement and easy installation.
Why Choose Our Product
Premium Quality
Our Engine Oil Filter Adapter Housing with Sensors is manufactured from quality materials, 100% tested before shipping.
Excellent Performance
Stable characteristics, high reliability. Designed to meet or exceed the standards of original factory Engine Oil Filter Adapter.
Easy Installation
Direct Replacement. Exact Fit for plug and play. (Please see below for more details)
When the oil filter housing is leaking oil, it’s easy to lose confidence in your car’s reliability. Replacement when it’s needed will restore your faith in your car.
As well, running your engine for a long time with a leaking oil filter housing can result in extensive engine damage.
While it’s leaking, close attention should be paid to the engine oil level to prevent an overheated or seized engine.
Removal
1.Release fuel system pressure.
2.Drain the cooling system.
3.Remove the lower intake manifold
4.Disconnect the oil temperature sensor and oil pressure sensor electrical connectors.
5.Remove five bolts and lift the oil filter housing.
6.Remove the coolant hose from the housing.
Installation
1.Lubricate the O-ring seal on the new housing with clean engine oil.
2.Install the coolant hose to the filter housing.
3.Place the oil filter housing on the engine block.
4.Tighten the housing bolts in the following sequence to 106 in. lbs.
5.Connect the oil pressure sensor electrical connector.
6.Connect the oil temperature sensor electrical connector.
7.Install the lower intake manifold.
8.Fill the cooling system.
